The manner in which the damage was repaired will be determined by the kind of Anchor that was used. If they were of the plastic variety, you may use a razor blade to remove the head of the screw and then just drive it into the wall. Then patch the hole in the plaster. If it’s made of metal, things get a little more complicated because the head can’t be cut off with a razor.
How do you remove an anchor from drywall without breaking it?
Position a screwdriver with a flat blade so that it spans the aperture of the drywall anchor.Check that the head of the screwdriver is broader than the screw hole in the anchor before using it.To drive the anchor all the way into the wall, use the end of the screwdriver as a mallet and tap it with the hammer.
- Continue tapping in that direction until the anchor is dislodged from behind the drywall.
What size screwdriver do I need to remove a wall anchor?
Because you will need to be able to push the wall anchor through the wall without making the hole wider, the screwdriver shouldn’t be any larger in diameter than the wall anchor itself. You may also remove the insert by drilling it out with a drill bit measuring 0.64 centimeters (1/4 inch).
How do plastic wall anchors work?
The plastic cylindrical anchors contain a hole in the middle that allows for the screw to be drilled in or a nail to be hammered into place. After being inserted into a hole that has been pre-drilled in the wall, the wall anchor will expand and secure itself to the drywall.
How do you sharpen drywall anchors with a razor?
Under the collar, you should slide one of the utility razor blades. It is important that the blade be sharp and that it is positioned so that it is flush with the wall. Do not move the blade closer to the wall since this might cause the surface of the drywall to get damaged. Not only does this procedure work well with plastic anchors, but it also works well with metal anchors.